3-62 ENGINE
• Remove the gearshift cam bearing with the special tools.
% 09923-74511: Bearing remover
09930-30104: Sliding shaft
Installation
• Install the bearings with the special tool.
% 09913-70210: Bearing installer set (
1 +20)
(
2 +32)
NOTE:
The stamped mark side of the gearshift shaft bearing
1 and
gearshift cam bearing
2 faces outside.
• Install the gearshift cam
3 with the bearing
4.
NOTE:
The stamped mark side of the gearshift cam bearing faces out-
side.
• Install the gearshift forks and their shafts as shown.
5 For 4th drive gear
6 For 3rd driven gear
7 For 5th driven gear
To Next Page
Loading...
