AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-167
3) Tighten final gear bolts (1) to specified torque.
Tightening torque
Final gear bolt
(a): 78 N·m (7.8 kg-m, 56.5 lb-ft)
4) After applying A/T fluid to output shaft speed sensor (VSS)
drive gear (1), install output shaft speed sensor drive gear.
5) Install new differential side RH bearing (1) by using special
tool and hydraulic press.
Special tool
(A): 09913-70123
6) Install new differential side LH bearing (1) by using special
tool and hydraulic press.
Special tool
(A): 09913-70123
2. Final driven gear
NOTE:
• To avoid rust, apply A/T fluid to final driven gear after
installation.
NOTE:
Replace differential side RH bearing together with bear-
ing cup as a set.
NOTE:
Replace differential side LH bearing together with bear-
ing cup as a set.
To Next Page
Loading...
