16. STEERING / FRONT WHEEL / FRONT CUSHION
16-5
Front Wheel
Remove
First by the bracket strut frame base, causes the
front wheel to float off.
Remove the speedometer cable.
Turn loose the axle nut.
Pull out the front wheel axle.
Remove the front wheel.
Caution
Care shall be taken not to push the brake lever
to avoid the brake pad being squeezed out. In
case that the brake pad is accidentally squeezed
out, use a screwdriver to force it back to the
place.
Inspection
Wheel axle
Place the wheel axle on a V block, measure its run
out.
Service limit: 0.2 mm
Bearing
Use finger to move the inner ring of each bearing,
it shall move smoothly and quietly. Check the
outer ring is securely attached on the wheel hub.
If the motion of the inner ring of the bearing is not
smooth, or noisy and loose when being moved,
remove and discard it.
Caution
The bearing shall be replaced in pair.
Wheel axle
Free play
Free play
Shaft nut
Speedometer cable
Wheel axle
To this chapter contents
To Next Page
Loading...
