17. REAR WHEEL / REAR FORK / REAR CUSHION
17-2
Precautions in Operation
General
Please refer to the Maintenance Manual for tubeless tire in respect to the removal, repair and installation
of the tires.
Service data Unit: mm
Item Standard Allowable Limit
Radial - 2.0
Run-out of rear rim
Axial - 2.0
Thickness of rear brake lining 5.1 2.0
Sustaining stroke of rear cushion 72 -
Torque Value
Rear wheel shaft nut 10.0~12.0kgf-m
Rear cushion upper bolt 3.5~4.5kgf-m
Rear cushion under bolt 2.4~3.0kgf-m
Rear fork mounting bolt 4.0~5.0kgf-m
Exhaust muffler mounting nut 1.0~1.2kgf-m
Exhaust muffler mounting bolt 3.2~3.8kgf-m
Troubleshooting
Run-out of rear wheel
y Deformed or bent wheel hub.
y Improper tires.
y Loose wheel shaft.
Soft Cushion
y The spring is too weak.
Noisy Brake
y Worn brake lining.
y Offset brake disc.
y Improper assembly of brake caliper.
y Brake disc or wheel imbalance.
Poor Performance of Brake
y Improperly adjusted brake.
y Contaminated brake disc.
y Worn brake lining.
y Air inside brake fluid pipe.
y Grease on brake disc.
y The brake fluid piping is clogged.
y The brake fluid pipe is deformed or bent.
y Insufficient amount of brake fluid in the
reservoir.
To this chapter contents
To Next Page
Loading...
