16. STEERING / FRONT WHEEL / FRONT CUSH
16-10
Install the steering stem mounting nut and tighten
the nut by means of holding the top cone race
body.
Torque value: 1.0~2.0kgf-m
Install in reverse order of removal procedures.
Shake steering handle up & down, left & right, and
front & rear to check if it is loosen, has too much
resistance and pulls to one side.
Check steering handle if it is being pulled too tight
by the brake cables.
Steering lock nut
Top cone-race
To this chapter contents
To Next Page
Loading...
