RS-232 Interface 8 - 15
RTS Line State
This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High
RTS line state.
Beep on <BEL>
Point-to-Point Mode Only
When this parameter is enabled, the digital scanner issues a beep when a <BEL> character is detected on the
RS-232 serial line. <BEL> is issued to indicate an illegal entry or other important event.
*Host: Low RTS
Host: High RTS
NOTE This parameter is not supported in Multipoint-to-Point Mode.
Beep On <BEL> Character
(Enable)
*Do Not Beep On <BEL> Character
(Disable)
To Next Page
Loading...
