Issue 3: Mar 96 TMSL 097-45018-02
Page 57
REPORT ALARM (Contd)
conddescr: ALARM INDICATION = received alarm indication
SIGNAL RECEIVED
CARD FAIL = card has failed
CLOCK ACTIVE = clock is active
CLOCK FREERUNNING = clock is in the freerunning mode
CLOCK IN HOLDOVER = clock is in the holdover mode
CLOCK NOT CONVERGED = clock is not locked to the input signal
DISCIPLINING REFERENCE = timing input has switched to another
SWITCHED reference
EXPANSION MAJOR = expansion shelf has a major alarm
EXPANSION MINOR = expansion shelf has a minor alarm
FRAMER FAILURE = framing
FUSE OR POWER FAIL = fuse or power at DCD system has failed
INPUT OUT OF TOLERANCE = input signal is out of the clock unitÕs
pull-in range
INPUT ACTIVE = input signal is active
LOSS OF SIGNAL = signal is lost
LOSS OF ALL PRIMARY = all primary timing input references have
TIMING INPUT been lost
REFERENCES
OUTPUT SYNC PORT FAIL = output port on an output card has failed
SYNC INPUTS UNLOCKED = synchronization inputs are unlocked
SYNC INPUT FAILED = input reference signal input has failed
SYNC SYSTEM FAIL = entire system has failed
THRESHOLD VIOLATION = bipolar violation threshold has been
FOR BPV exceeded
THRESHOLD VIOLATION = cyclic redundancy check threshold has
FOR CRC been exceeded
THRESHOLD VIOLATION = fractional frequency threshold has been
FOR FFREQ exceeded
THRESHOLD VIOLATION = an MTIE threshold has been exceeded
FOR MTIE OBSERVATION
THRESHOLD VIOLATION FOR = threshold for MTIE 1-second
MTIE1 OBSERVATION observation has been exceeded
THRESHOLD VIOLATION = threshold for MTIE 4-second
FOR MTIE4 OBSERVATION observation has been exceeded
THRESHOLD VIOLATION = threshold for MTIE 16-second
FOR MTIE16 OBSERVATION observation has been exceeded
THRESHOLD VIOLATION = threshold for MTIE 64-second
FOR MTIE64 OBSERVATION observation has been exceeded
THRESHOLD VIOLATION = threshold for MTIE 128-second
FOR MTIE128 OBSERVATION observation has been exceeded
THRESHOLD VIOLATION = threshold for MTIE 512-second
FOR MTIE512 OBSERVATION observation has been exceeded
THRESHOLD VIOLATION = threshold for MTIE 900-second
FOR MTIE900 OBSERVATION observation has been exceeded
THRESHOLD VIOLATION = out-of-frame threshold has been exceeded
FOR OOF
To Next Page
Loading...
Need help?
General
