SECTION II- USER KEY OPERATIONS
20
already in use. If an in-use hose is selected, a message will appear
telling you to select a different hose.
Once a hose has been selected, one of two messages appears on
the FMU display. These messages depend upon the type of
dispenser installed and how it was wired during installation of the
FuelMaster® hardware.
This authorization prompt appears if the FMU configuration is set to not
detect the pump handle. It does not matter when the pump handle is
turned on. When this message appears, the FMU is ready to track
fueling.
<< TURN ON PUMP HANDLE TO DISPENSE >>
<< THE SELECTED PRODUCT >>
This authorization prompt is display if the FMU configuration is set to Pump
Handle Detect. It indicates that the FMU is ready to wait for the pump handle to
be turned on.
The following prompt indicates the dispenser hose status.
>>> DISPENSER HAS BEEN ACTIVATED <<<
>>> RETURN HOSE AFTER USER <<<
When the FMU detects that the pump handle is turned on, it responds with
the above message and is ready to track fueling.
** PUMP HANDLE NOT TURNED OFF. **
** PLEASE TURN PUMP HANDLE OFF! **
If the above message appears, the pump handle selected was already in the
‘ON’ position at the time this handle was selected. To begin fueling with this
pump handle, first reset the pump handle to the ‘OFF’ position and wait for the
prompt to turn it on to begin fueling.
Electronic dispenser
*** DISPENSER ENABLED ***
*** DISPENSE PRODUCT ***
Mechanical dispenser
**TURN ON PUMP HANDLE TO DISPENSE
THE SELECTED PRODUCT**
To Next Page
Loading...