SECTION V- MANUAL KEY OPERATIONS
35
VVID systems which validates the Vehicle ID entry made on the FMU keypad.
This option is disabled by default and must be enabled by Syn-Tech Product
Support personnel.
With the Verify Vehicle ID feature enabled, the VEHICLE ID is then validated
against the stored list of authorized vehicles. If the entry is invalid, a message is
sent to the on-site printer and the process begins again. If the entry is a valid
VEHICLE ID, the next prompt appears on the FMU display.
COMMERCIAL & VVID SYSTEM TYPES ONLY:
***** FUELMASTER *****
ENTER CHRONO/ODOMETER --->
The CHRONO/ODOMETER reading is recorded without being checked.
A new 2500 Series FMU feature allows you to disable the Agency ID entry
requirement for Commercial systems. This must be set before shipping or
enabled by Syn-Tech Product Support personnelCustomer Satisfaction
Center.
If this feature has not been enabled or you do not have a Commercial
System type, the following AGENCY ID entry prompt appears:
***** FUELMASTER *****
ENTER AGENCY ID --->
This entry is accepted without being checked.
ALL SYSTEM TYPES:
Once responses to all prior prompts are entered, hose selection is made and
fueling allowed.
REMOVE KEY, SELECT HOSE, PRESS <ENTER>
1,2,3,4,5,6,7,8 --->
To Next Page
Loading...