SECTION VII - SUPERVISOR KEY ACCESS
46
AIM > RESET
This option resets the AIM unit provided the programming hose tag is
inserted.
SUPERVISOR CONFIG MENU
CONFIGURATION: <TIME> <DATE> <DAY OF WK>
A=MODIFY, B=TESTS, C=TIME/DATE, D=EXIT
CONFIG > MODIFY
By selecting Option A, Modify from the Configuration submenu, the following
menu appears:
CONFIG MENU: 1=COMM, 2=TOTALIZERS
A=PUMPS, B=SYSTEM, C=SHOW OPTIONS, D=EXIT
CONFIG > MODIFY > COMM
By selecting Option 1 of the Modify Configuration submenu, the following
submenu appears:
COMMUNICATIONS MENU:
A=BAUD RATE, D=EXIT
NOTE:
If a Network Interface Card is installed on the main board of the
FuelMaster®, an additional “Network Card” option will appear in the
Communications Menu.
COMMUNICATIONS MENU:
A=BAUD RATE, B=NETWORK CARD, D=EXIT
CONFIG > MODIFY > COMM > BAUD RATE
BAUD RATE MENU: 1 = TANK MONITOR UNIT,
2 = RECEIPT PRINTER, 3 = MODEM, D = EXIT
The Tank Monitor Unit, receipt printer, and modem baud rates may be
changed by first selecting the device to modify and then pressing ‘A’ on
the keypad to scroll through the baud rate selections. Once a baud rate
To Next Page
Loading...