SECTION VII - SUPERVISOR KEY ACCESS
41
SECTION VII -SUPERVISOR KEY ACCESS
The Supervisor Key, once encoded, should remain with the person responsible
for the system or in a safe location. Although it is a very useful key, since it
allows access to the system’s configuration features, it can also be a dangerous
key in the wrong hands.
NOTE:
Menu options and prompts listed in this section may differ slightly depending on
the hardware configuration of a particular FuelMaster®. Hardware or
configuration dependent options will be noted as such. Additionally, options may
change if the FuelMaster® Unit has been configured to operate as any system
type other than the standard FuelMaster® System, such as a GateMaster® or
WasteMaster®.
SUPERVISOR KEY SYSTEM PROCEDURES
** FUELMASTER FUELS ACCOUNTING SYSTEM **
** INSERT KEY, HOLD 1 SECOND TO BEGIN **
The above default FuelMaster® message displays continuously when the
FuelMaster® (FMU) is available for use.
If your system is equipped with a credit card reader, the following prompt is used
instead of the prior prompt as the FMU’s default prompt:
** FUELMASTER FUELS ACCOUNTING SYSTEM **
** INSERT KEY OR CARD TO BEGIN **
Once a supervisor key is inserted, the following menu is displayed:
* SUPV. MENU: 1=SYSTEM, 2=PM, 3=ODOM 4=AIM *
* A=CONFIG, B=ISSUES, C=TANKS, D=EXIT *
Options 1-3 and A-C represent a set of submenus which may have additional
submenus. From the Main Menu, pressing ‘D’ will exit supervisor key operations.
Pressing the ‘D’ key within in a submenu will back up to the previous menu.
To Next Page
Loading...