SECTION VII - SUPERVISOR KEY ACCESS
43
SYSTEM > CREDIT CARD
The Credit Card Menu offers options for initializing credit card operations.
The menu shown below has three credit card networks available. (Your
menu options may differ slightly depending on your cc network). For
detailed credit card operations, please refer to the Card Reader
Supplement provided with your card reader system.
CC MENU: 1=PRINT CONFIG, 2=CFN MENU
3=FLEETCOR MENU, 4=NBS MENU, D=EXIT
SYSTEM > CREDIT CARD > PRINT CONFIG
Sends the credit Card network configuration to the onsite printer.
SYSTEM > CREDIT CARD > NETWORKS
There may be one or more credit card network menus listed depending on
the specific configuration. Each network menu provides options to disable
and enable the network in addition to batch management and settlement
options.
NOTE:
If a credit card reader is not installed, the following message will appear
when attempting to access the credit card menu:
** CARD READER NOT INSTALLED IN **
** THIS FMU. INVALID OPERATION! **
SYSTEM > TOTALIZER
Used to set or reset the totalizer value of each pump. At the first prompt, enter
the desired pump number. Then enter the new totalizer value for the pump. If
a different value is entered from the current totalizer value, a message will
appear to confirm the change.
SYSTEM > CLOSEOUT
Marks all inventory management transactions as being closed by the
supervisor.
SYSTEM > FLASH
Select from a list of available firmware image files located on the Compact
Flash card. This file is then written to RAM after a backup of the current
image file is created.
To Next Page
Loading...