SECTION I - VEHICLE KEY OPERATIONS
10
SECTION I - VEHICLE KEY OPERATIONS
Vehicle Key FMU Configuration
The system types that use vehicle keys are the COM (Commercial)
systems which have one of the following key configurations: VKO (Vehicle
Key Only), Either Key or Two Key and the VMN (Verified Miscellaneous
Number) systems. (Prompts specific to Either-Key and Two-Key Systems
are detailed in Sections III & IV of this manual.)
Vehicle Key systems are designed to provide accurate fueling records as
they relate to the activities of a particular vehicle. These records may also
contain User information depending on the configuration of the unit and
the key options selected.
Vehicle Key Operation Prompts
If the Odometer/Chronometer feature is enabled, note the current
odometer/chronometer reading before getting out of the vehicle.
The FMU screen displays the following prompt:
** FuelMaster FUELS ACCOUNTING SYSTEM **
** INSERT KEY, HOLD 1 SECOND TO BEGIN **
This message indicates that the FMU is available for use. Insert the ProKee®
into the ProKee® receptacle. Press it in and hold it there until the display screen
on the FMU changes to the next prompt (approximately one second).
NOTE
:
If your system is equipped with a credit card reader, the following prompt is used
instead of the prior prompt as the FMU’s default prompt:
** FUELMASTER FUELS ACCOUNTING SYSTEM **
** INSERT KEY OR CARD TO BEGIN **
If the FMU’s PIN option is enabled and the vehicle key’s PIN option is set to
Y (this is done in the Central Controller software when a ProKee® is being
encoded), the following prompt will appear:
To Next Page
Loading...