SECTION VII - SUPERVISOR KEY ACCESS
42
SUPERVISOR SYSTEM MENU
SYSTEM MENU: 1=REPORTS, 2=CREDIT CARD,
4=TOTALIZER, 5=CLOSEOUT, 6=FLASH, D=EXIT
SYSTEM > REPORTS
The Reports Menu offers a variety of report options, all of which are sent
immediately to the on-site printer.
REPORTS: 1=ERR LOG, 2=EVENTS, 3=ERR DUMP,
4=LCD, 5=REPRINT, A=CFG, B=EIU CFG, D=EXIT
SYSTEM > REPORTS > ERR LOG
Prints the last 64 errors in the ‘System Error’ category.
SYSTEM > REPORTS > EVENTS
Prints any changes made in the FMU since the last upload from the
Central Controller.
SYSTEM > REPORTS > ERR DUMP
Prints system error status and gives specific error info.
SYSTEM > REPORTS > LCD
Prints the last 199 LCD displays which presented on the FMU.
SYSTEM > REPORTS > REPRINT
Reprints the print buffer to onsite printer.
SYSTEM > REPORTS > CFG
Prints the FMU’s current configuration to the on-site printer. This
configuration report is a useful to keep close at hand. If a problem arises,
it is invaluable when having to rebuild the system’s configuration. This
report is also a handy reference when setting up the site configuration in
the FuelMaster® software.
SYSTEM > REPORTS > EIU CFG
If the unit is equipped with EIU satellite units, selecting this report prints
the current configuration for each of these units. Again, this is a handy
reference should a problem arise.
To Next Page
Loading...