SECTION VIII -ERROR MESSAGES & TROUBLESHOOTING
61
** ERROR: PUMP HANDLE NOT TURNED ON **
** TRANSACTION HAS BEEN CANCELLED **
When using "Pump handle YES" in the configuration, the user must select the
hose number before turning the handle on. In some cases, selection of
"Pump Handle NO" may be needed to resolve this situation.
** TIME LIMIT EXCEEDED OR **
** TRANSACTION WAS CANCELLED ! **
VALID KEY TIMEOUT was reached or CLEAR/NO was pressed on the
keypad and confirmed to cancel transaction.
CONFIGURATION ERROR . . . SYSTEM SHUTDOWN !
ENTER 3 - DIGIT AUTH. CODE TO EDIT CONFIG.
WHILE DOING SELF-TEST DURING POWER-UP, FMU MISREAD SITE
CONFIGURATION STORED IN EEPROM
Enter the code of 3A3 to have FMU try again. The prompt responds with the
following:
RESET CONFIGURATION DATA?
YES = INITIALIZE, NO = USE OLD
INITIALIZE USING OLD OR NEW? YES/NEW, NO/OLD
Press NO to instruct FMU to look for and use old configuration (site
configuration stored in EEPROM).
Press YES to have FMU use default factory configuration. WARNING! Any
previous configuration data is reset. See NOTE below.
NOTE:
Always select NO to use old configuration. If FMU returns to Config error, contact
STS.
** TESTING NOT ALLOWED WHILE HOSES ARE **
** IN USE! PLEASE TRY AGAIN LATER ! **
To Next Page
Loading...