SECTION III- EITHER KEY OPERATIONS
22
Enter the PIN (Personal Identification Number) of the Vehicle of User Key
on the FMU keypad. This number is assigned to the key when it is
encoded and is a 4-digit number that is unique to the key. If your entry is
incorrect, an error message appears
***ERROR: INVALID P.I.N ENTERED***
***RE-INSERT KEY TO TRY AGAIN***
VEHICLE KEY SPECIFIC SYSTEM PROCEDURES
If the ‘Verify User Key ID Entry’ option is enabled in the FMU’s
configuration, (this system option is disabled by default but can be
enabled by contacting Syn-Tech’s Product Support personnel) the
following prompt appears:
***** FUELMASTER *****
ENTER USER ID --->
Enter the User ID on the FMU keypad. This must match the User ID
stored in the key. If the entry is invalid, the process begins again. If
accepted, the next applicable prompt appears.
IMPORTANT NOTE:
???If the ‘Odometer First’ option is enabled in the FMU’s
configuration, of the next two prompts (User ID and Odometer)
Odometer will appear first. (This option is ‘disabled’ by default but
may be changed by contacting Syn-Tech’s Product Support
personnel.)
If the USER option is enabled, the following prompt appears:
***** FUELMASTER *****
ENTER USER ID --->
This prompt requires entry of a USER ID on the FMU keypad. Remember
that this may be alphanumeric and may be up to nine characters in length.
(The USER ID prompt may be customized to request other than USER ID
To Next Page
Loading...