EasyManua.ls Logo

Syn-Tech Systems FuelMaster Plus - Odometer Error Resolution and Cancellation

Default Icon
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION III- EITHER KEY OPERATIONS
24
the miles/hours range on the key was too low to begin with,
tenths of miles may have been entered when the entry should
contain whole miles only,
the last time the key was used the miles/hours did not get written
back to the key,
an incorrect entry was made and the ENTER/YES key was pressed,
the entry is correct but the vehicle's last fueling was off-site causing
the mile/hour range to be exceeded.
The above error messages require re-entry of mileage or hours. An FMU with
default configuration will accept the user's second mile/hour entry, regardless of
accuracy.
** REINSERT YOUR VEHICLE KEY **
** TO CONTINUE **
This message indicates that the miles/hours entry was accepted and the FMU
wishes to write the entry back to the key. Insert the Vehicle Key and hold it in
after prompted. The entry is written back to the key and the next prompt appears.
If the ‘Bad Odom Termination’ option is enabled on the FMU, the following
display appears upon entry of two consecutive odometer entries which are out of
range of the odometer written to the key.
** TRANSACTION CANCELLED BECAUSE OF **
** OUT-OF-RANGE ODOMETER ENTRIES **

Table of Contents

Related product manuals