SECTION IV- TWO KEY OPERATIONS
32
Insert the Vehicle Key so that the miles/hours can be written back on the
Vehicle Key.
If the preventive maintenance option is enabled, the following prompt may
appear:
** VEHICLE IS DUE FOR PREVENTATIVE **
** MAINTENANCE --INFORM SUPERVISOR **
This message indicates that the PM MILEAGE that was encoded on the
key has been reached and preventive maintenance is due. This message
continues to be displayed for this vehicle until the Vehicle Key is updated
(PM MILEAGE is reset) by the supervisor. (This message is displayed for
the time period specified in the Configuration Setting, ‘Message Read
Duration’. The default for this setting is 4 seconds.)
Once all entries have been completed, the following hose selection screen
appears:
REMOVE KEY, SELECT HOSE, PRESS <ENTER>
1,2,3,4 --->
This selection is limited to those hoses with the same product code(s)
authorized for the Vehicle Key and the User Key. Make the hose selection
and press ENTER/YES.
Once a hose has been selected, one of two messages appears on the
FMU display. The prompt selection depends upon the type of dispenser
installed and how the control wiring was done during installation of the
FuelMaster® hardware:
*** DISPENSER ENABLED ***
*** DISPENSE PRODUCT ***
This authorization prompt appears if the FMU configuration is set at pump handle
detect - NO. It does not matter when the pump handle is turned on. When this
message appears, the FMU is ready to track fueling.
<<< TURN ON PUMP HANDLE TO DISPENSE >>>
<<< THE SELECTED PRODUCT >>>
This authorization prompt appears if the FMU configuration is set to Pump
Handle - YES. It indicates that the FMU is ready to watch for the pump handle to
To Next Page
Loading...