TA Instruments DSC Autosampler CE - Installing the Crimping die

Preparing Samples
5–4 TA I NSTRUMENTS DSC A UTOSAMPLER CE
Installing the
Crimping Die
The Autosampler CE comes equipped with a
crimping die designed to work with the TA
Instruments Autosampler CE crimped pans.
Follow the steps below to install the crimping die
in the Sample Encapsulating Press before
preparing crimped pans for Autosampler CE use.
1. Loosen the lower die holder thumbscrew on
the Sample Encapsulating Press.
Figure 5.1
The Lower Die
Holder Thumbscrew