Need help?Do you have a question about the TA Instruments RSA-G2 and is the answer not in the manual?
General| Type | Dynamic Mechanical Analyzer (DMA) |
|---|---|
| Temperature Range | -150°C to 600°C |
| Strain Range | 0.01% to 100% |
| DMA Capability | Yes |
| Tensile Testing Capability | Yes |
| Compression Testing Capability | Yes |
| Shear Testing Capability | Yes |
| Bending Testing Capability | Yes |
| Control Mode | Force, Displacement |
| Sample Size | Varies depending on geometry (e.g., rectangular, cylindrical) |
| Software | TRIOS Software |
Outlines the various parts and configurations that make up the RSA-G2 system.
Describes the main components of the RSA-G2 test station, including the motor and keypad.
Explains the interactive functions and displays available on the instrument's touch screen interface.
Introduces the Forced Convection Oven (FCO) as the primary environmental system.
Covers unpacking, system preparation, moving, and choosing a location for the instrument.
Details connecting the air dryer, ports, cables, power supplies, and signal panel.
Provides instructions for leveling the RSA-G2 and managing its power states.
Covers essential calibration tasks like geometry mass, phase angle, and force calibration.
Offers recommendations for choosing and installing appropriate sample geometries for testing.
Outlines running tests, routine maintenance, and replacement parts for the instrument.
Highlights important notes, cautions, warnings, and instrument symbols for safe operation.
Details safety precautions for high voltages, hot/cold surfaces, and hazardous environments.
Advises on keeping clear of moving parts and lists relevant regulatory compliance standards.
To Next Page
