EasyManuals Logo

TA Instruments RSA-G2 User Manual

TA Instruments RSA-G2
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background image
RSA-G2 Getting Started Guide Page 21
Environmental Control Unit
The FCO is the only environmental system available for use with the RSA-G2. There are two optional
subambient controllers for use with the FCO: LN2 Controller and Gas Chiller.
Refer to the following sections for basic information regarding each specific environmental option. For
more details, refer to the online help available in the TRIOS software.
NOTE: See TRIOS Help for installation information regarding all of the environmental control units.
Forced Convection Oven (FCO)
NOTE: For FCO installation instructions, refer to TRIOS software Help.
DANGER: Do not remove the outer or inner covers of the oven, as high voltage (200 VAC) exists
inside the oven when the oven is on.
DANGER: Ne déposez pas les couvercles externes ou internes du four, en raison de la présence
d'une tension élevée (200 VCA) dans le four lorsqu'il est allumé.
DANGER: Do not touch the outer cover when the oven is running, as the outer covers can get
very hot. Only touch the FCO handle, if necessary.
When opening the oven to load samples, the heaters and the gas flowing through the heaters
shut off. However, the geometries remain hot, as does the air around the sample area. There-
fore, show care when loading and trimming your sample.
DANGER: Ne touchez pas le couvercle extérieur lorsque le four est en marche, car les couver-
cles extérieurs peuvent devenir très chauds. Ne touchez le manche du FCO que si c'est néces-
saire.
Lorsque vous ouvrez le four pour la mise en place des échantillons, les réchauffeurs et le gaz
qui s'écoule à travers les réchauffeurs s'arrêtent. Cependant, les géométries restent chaudes
de même que l'air autour de la zone de l'échantillon. Par conséquent, soyez prudent lors de la
mise en place et de l'ajustage de votre échantillon.
When running the oven above 45C, make sure the special heat shield is installed on the trans-
ducer frame.
Lorsque le four fonctionne à plus de 450° C, assurez-vous que l'écran thermique spécial est
installé sur le châssis du transducteur.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TA Instruments RSA-G2 and is the answer not in the manual?

TA Instruments RSA-G2 Specifications

General IconGeneral
BrandTA Instruments
ModelRSA-G2
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals