TA I
NSTRUMENTS
DSC A
UTOSAMPLER
CE 3–5
Starting the Autosampler CE
Switching from
Automatic to Manual Mode
1. Access the Autosampler CE keypad by
loosening the captive thumbscrews on the
keypad cover and tilting the cover down.
2. Press the HALT key on the Autosampler CE
keypad. The display reads:
Automatic Mode
Halted
3. Press the MANUAL/AUTOMATIC key.
The display reads:
Manual Mode
Idle
The Autosampler CE is now in manual mode
and is ready for a command from the
Autosampler CE keypad. The display will
read Idle until you press a key.
When you have finished using the Autosampler
CE keypad, remember to close the keypad cover
and finger-tighten the thumbscrews before
starting a method.
NOTE:
To Next Page
Loading...