TA Instruments DSC Autosampler CE User Manual

TA I NSTRUMENTS DSC A UTOSAMPLER CE 3–9
Moving the Turret Assembly
Changing the
Motor Speed
The SPEED key enables you to change the
speed of manual Autosampler CE movement.
The speed you select applies only to the motion
keys; when the Autosampler CE is executing
commands from the controller or one of the
Autosampler CE command keys (LOAD, LIDS),
the speed is preset and is not affected by your
selection.
1. Access the Autosampler CE keypad by
loosening the captive thumbscrews on the
keypad cover and tilting the cover down.
2. Press the SPEED key. The Autosampler CE
displays the current speed. For example:
Motor Speed
7 Selected
3. Select a new speed by pressing a numeric
key from 0 to 9, then pressing ENTER. The
lowest speed is 0, the highest is 9, and the
default is 7 (automatically selected when you
turn on the Autosampler CE).
When you have finished using the Autosampler
CE keypad, remember to close the keypad cover
and finger-tighten the thumbscrews before
starting a method.
NOTE:

TA Instruments DSC Autosampler CE Specifications

General

Brand	TA Instruments
Model	DSC Autosampler CE
Category	Laboratory Equipment
Language	English