TA Instruments DSC Autosampler CE User Manual

Preparing the Autosampler CE
2–4 TA I NSTRUMENTS DSC A UTOSAMPLER CE
Preparing for
Operation
Connecting the
Heat Exchanger Cable
When you place the LNCA heat exchanger on
the DSC instrument with an Autosampler CE,
you need to connect the heat exchanger cable to
the instrument. (The LNCA Operators
Manual contains more details on installing the
heat exchanger.) Connect the heat exchanger as
follows:
1. Make sure that the DSC 2920 POWER
switch is in the off position.
2. Plug the end of the heater exchanger cable
into the electrical assembly as shown in
Figure 2.1.
Figure 2.1
Plugging in the
Heat Exchanger Cable

TA Instruments DSC Autosampler CE Specifications

General

Brand	TA Instruments
Model	DSC Autosampler CE
Category	Laboratory Equipment
Language	English