TA Instruments DSC Autosampler CE User Manual

Preparing the Autosampler CE
2–6 TA I NSTRUMENTS DSC A UTOSAMPLER CE
Installing the
Dust Cover
The plastic dust cover that comes with the
Autosampler CE should be in place whenever
you leave the Autosampler CE to run a series of
samples. This will prevent dust and dirt from
interfering with your experiments.
To put the dust cover on, simply insert the lip into
the slot on the right side of the console and lower
the dust cover down.
The dust cover is not used when you are using
the RCS with the environmental chamber on the
Autosampler CE.
NOTE:

TA Instruments DSC Autosampler CE Specifications

General

Brand	TA Instruments
Model	DSC Autosampler CE
Category	Laboratory Equipment
Language	English