TA Instruments DSC Autosampler CE User Manual

TA I NSTRUMENTS DSC A UTOSAMPLER CE 5–21
Figure 5.10
Placing the
Cover over
the Crimped Pan
6. Pull the sample press lever forward, and
push down gently until the lever stops
moving.
7. Raise the lever, and remove the pan from
the well. Check the pan to ensure that it
meets the specifications outlined in Table 5.1
(next page).
If the pan does not meet the specifications in
Table 5.1, you may need to adjust the height
of the lower die. To adjust the lower die,
loosen the lower die holder thumbscrew (see
Figure 5.1), and follow steps 9 through 11 on
page 5-8.
Preparing Sample Pans

TA Instruments DSC Autosampler CE Specifications

General

Brand	TA Instruments
Model	DSC Autosampler CE
Category	Laboratory Equipment
Language	English