TA Instruments DSC Autosampler CE User Manual

Using the Autosampler CE in the Manual Mode
3–14 TA I NSTRUMENTS DSC A UTOSAMPLER CE
5. Select a tray position:
 Press ENTER to select sample pan 0,
and the Autosampler CE will unload the
selected pan back to the tray position
from which it was originally loaded.
OR
 Type a number between 1 and 62 to
select a different tray position, then
press ENTER.
If you load pans into the DSC cell by hand or
press RESET SAMPLER after loading them with
the LOAD key, you must enter a returning pan
number (you cannot use sample pan number 0).
Press RESET SAMPLER to clear the Autosam-
pler CE’s memory whenever you remove a pan
from the DSC cell with tweezers. If you do not,
the Autosampler CE assumes that the pan is
still in the cell, and if you later start a run on the
controller, the Autosampler CE attempts to
remove the pan and halts when it cannot find
the pan.
When you have finished using the Autosampler
CE keypad, remember to close the keypad cover
and finger-tighten the thumbscrews before
starting a method.
NOTE:
NOTE:
NOTE:

TA Instruments DSC Autosampler CE Specifications

General

Brand	TA Instruments
Model	DSC Autosampler CE
Category	Laboratory Equipment
Language	English