TAJIMA TEHX-C - 3. MANUAL OFFSET;DESIGN START POSITION

CHAPTER 7 MANUAL OPERATION
68
3. MANUAL OFFSET/DESIGN START POSITION
<How to call the screen>
Manual offset
Return the frame that was moved to the orig-
inal position.
Manual offset p.98
Design start position
The frame will move to start position of
design.
WARNING
When performing this operation, do not put your hands under the
needle or on the machine table. If your hands are under the needle
or on the machine table, you may be injured by the needle or the
moving frame.
(GC03)
Xa:43.2
Ya:-276.1
!
Screen 1400
2
1
OK?
Xa:43.2
Ya:-276.1
Screen 1400
2
1
OK?
Xa:43.2
Ya:-276.1