TAJIMA TEHX-C - Total Stitch Counter; Display of M.shaft Stop Position; Display of Needle Position; Panel Software Install

CHAPTER 8 PARAMETER SETTING
91
51. Total Stitch Counter
52. Display of M.Shaft Stop Position
53. Display of Needle Position
54. PANEL Software Install
55. ------
(GC02)
It displays the number of embroidered stitches
until now since the counter is reset.
0: Reset
---: To display the counter
(---, 0)
0
0
-----
-----
No
No
4
0
51. Total Stitch Counter
( ---, 0, )
52. Display of M.Shaft Stop Position
( , )
53. Display of Needle Position
( , )
54. PANEL Software Install
( No, Yes, )
------
56. Stop at Lower D.Point
( No, Yes, )
57. Frame Travel Key
(4, 8, )
58. Adjust M.Shaft Stop Position
( -5 ~ +5, )
------
------
Display the stop position of the main shaft.
ON: within the range of the fixed position
OFF: Outside of the range of the fixed posi-
tion
ON
0
-----
-----
No
No
4
0
51. Total Stitch Counter
( ---, 0, )
52. Display of M.Shaft Stop Position
( , )
53. Display of Needle Position
( , )
54. PANEL Software Install
( No, Yes, )
------
56. Stop at Lower D.Point
( No, Yes, )
57. Frame Travel Key
(4, 8, )
58. Adjust M.Shaft Stop Position
( -5 ~ +5, )
------
------
Display the needle position.
465
0
-----
-----
No
No
4
0
51. Total Stitch Counter
( ---, 0, )
52. Display of M.Shaft Stop Position
( , )
53. Display of Needle Position
( , )
54. PANEL Software Install
( No, Yes, )
------
56. Stop at Lower D.Point
( No, Yes, )
57. Frame Travel Key
(4, 8, )
58. Adjust M.Shaft Stop Position
( -5 ~ +5, )
------
------
Install the PANEL software.
Installation p.20
(Yes/No)
No
0
-----
-----
No
No
4
0
51. Total Stitch Counter
( ---, 0, )
52. Display of M.Shaft Stop Position
( , )
53. Display of Needle Position
( , )
54. PANEL Software Install
( No, Yes, )
------
56. Stop at Lower D.Point
( No, Yes, )
57. Frame Travel Key
(4, 8, )
58. Adjust M.Shaft Stop Position
( -5 ~ +5, )
------
------
It is not applied.
0
-----
-----
No
No
4
0
51. Total Stitch Counter
( ---, 0, )
52. Display of M.Shaft Stop Position
( , )
53. Display of Needle Position
( , )
54. PANEL Software Install
( No, Yes, )
------
56. Stop at Lower D.Point
( No, Yes, )
57. Frame Travel Key
(4, 8, )
58. Adjust M.Shaft Stop Position
( -5 ~ +5, )
------
------