CHAPTER 7 MANUAL OPERATION
72
7. POWER RESUME (TEHX-C, TFHX, TFHX-C)
1. Machine stop code
Power resume function moves the frame to
the position where the power was shut off
during embroidery to prevent displacement
of design.
2. Selecting the thread trimming
Automatic thread trimming (ATH)
Selection and execution of thread trimming
will cause the frame to move automatically
after thread trimming to search the origin.
3. End
When the origin is searched, the frame will
return to the position where the power was
shut off and power resume operation will
finish.
WARNING
When performing this operation, do not put your hands under the
needle or on the machine table. If your hands are under the needle
or on the machine table, you may be injured by the needle or the
moving frame.
ATH - Not to perform thread trimming
ATH o To perform thread trimming
(FD11)
Turning on the power again
In case of power shut off by emergency stop,
turn “ON” the power to start operation.
In case of power shut off by power failure,
turn “OFF” the power and then turn it “ON”
to start operation.
!
Screen 1000
[2E3]
1
Screen 1000
ATH o
3
2
Screen 1000
4
To Next Page
Loading...
