Navigation
10 TASCAM DP-01 Owner’s Manual
Starting out with your DP-01
Shutting down the DP-01
If you don’t shut
down the DP-01 in
the way described here, you may
lose your recordings and settings.
Always shut down the DP-01 in
the way described here.
1 First, stop playback or recording.
2 Press and hold the SHUT DOWN key for about a second. The screen
shows:
3 Press ENTER to start the shut down process.
Pressing the
EXIT
key cancels the
shutdown process.
The display shows: Storing Song...
4 When the song data is stored to hard disk, the display shows:
5 You can now use the rear panel switch to turn off the DP-01.
The ACCESS light
Do not move the
DP-01 or turn it off
or disconnect the power when
the
ACCESS
indicator is lit, to
avoid damage to the hard disk
and possible loss of data.
This red indicator shows that the disk is in use. Although the DP-01 is not a very
delicate piece of equipment, you should take care with it, as with all electronic
equipment, especially when it is using its hard disk.
Navigation
The DP-01 uses a menu system which allows you to make settings, and perform
many operations. This section explains how to use the menu system and to
check and make settings.
Figure 1.2: SHUT DOWN and ACCESS
| SHUTDOWN |
|[ENTER] -> Exe|
| Complete |
| Now Sw Off |
Figure 1.3: Menu controls
To Next Page
Loading...
Need help?
General
