Tascam DP-01 - Pre-roll and post-roll times

Punching
30 TASCAM DP-01 Owner’s Manual
Advanced techniques
Punch recording
When you have rehearsed your punch recording, you can start recording.
1 Press the RHSL key so that the indicator goes out (but the AUTO
PUNCH indicator is still lit).
2 Press PLAY so that playback starts. Use the pre-roll time to get ready to
record.
At the punch-in point, the DP-01 goes into record mode (the
RECORD
indicator lights).
At the punch-out point, recording stops (the
RECORD indicator goes
out), and playback continues until the post-roll point and then returns
to the pre-roll point. The
AUTO PUNCH indicator is turned off (the
track arming status stays the same).
… If you want to re-record the punch, turn AUTO PUNCH back on before
recording again.
Pre-roll and post-roll times
The pre-roll and post-roll times can be set to suit your style of playing.
1 Press MENU and scroll down to PREFERENCE and press the y key.
The pre-roll and
post-roll times can
be set between 1.0 seconds and
9.9 seconds in 0.1 second steps
2 Use the cursor keys to move the cursor to the Pre (pre-roll time) item,
and use the wheel to set the value in seconds.
3 Use the cursor keys to move down to the Post (post-roll time) item and
the wheel to change the value.
4 Press EXIT when you’re done, so that you can start using these settings.
-- PREFERENCE --
Meter:S.Fat
Pre / 3.5Sec
Post :1.8Sec ;