Tascam DP-01 - Startup & shutdown

Starting out with your DP-01
TASCAM DP-01 Owner’s Manual 9
Startup & shutdown
Startup & shutdown
Read this section to understand how to power up and power down the DP-01.
When switching
the DP-01 on and
off, we suggest that you turn
down the volume of any speakers
or amplifiers connected to the
unit. Also, do not wear head-
phones connected to the DP-01
when switching power on or off.
This will avoid damage to speak-
ers, etc. and possible damage to
your hearing.
Starting up the DP-01
With the DP-01’s rear panel power switch OFF, connect the power adapter to
the DP-01, the power cable to the power adapter, and the power cable to the
power supply.
… Switch on the DP-01 using the rear panel switch.
… The DP-01 display shows a welcome message.
The system is loaded, and the last saved song is then loaded. The
ACCESS indicator lights to show the hard disk is in use while the song
is being loaded, and the display shows the current operation.
You can reach this
screen from most
operations by repeated presses of
the
EXIT key.
… When the ACCESS light goes off, the display shows the “home screen”:
Figure 1.1: Power connections to the DP-01
TASCAM
DP-01
ABS 00:00:00:00