Repeat
32 TASCAM DP-01 Owner’s Manual
Advanced techniques
Repeat
Repeat allows you to repeat the playback or auto-punched rehearsal (see
“Rehearsal” on page 29) between the IN and OUT points.
You can’t set these
points when the
REPEAT
key is lit.
… First, set the IN and OUT points at the place where you want the
repeat loop to start and stop (see “IN and OUT marks” on page 26).
… Press the REPEAT key briefly so that the indicator lights. Playback
starts automatically from the IN point.
… When the playback reaches the OUT point, playback pauses for a
short while (see “Setting the repeat interval” on page 32) and the
PLAY
indicator flashes before playback starts again, and the PLAY indicator
lights steadily.
… Turn off the repeat function by pressing REPEAT so that the indicator
goes out.
Repeat auto-punch rehearsal, but not repeat auto-punch recording, is
also possible. If
AUTO PUNCH, RHSL and REPEAT are all lit, pressing
RHSL to go from rehearsal to auto punch recording mode will also
turn off
REPEAT.
Setting the repeat interval
You can set the time between repeats up to 9.9 seconds.
This repeat inter-
val allows you to
reposition your hands for a guitar
lick, take a breath for a vocal
phrase, etc. when you are
rehearsing.
… Press and hold the REPEAT key for about a second, and the screen
shows:
Use the wheel to set the repeat interval from 0.5 seconds to 9.9 sec-
onds in 0.1 second steps.
… Press REPEAT again briefly to exit the interval setting mode.
ABS 00:02:34:21
----------------
REPEAT
INTERVAL / 1.7
To Next Page
Loading...
Need help?
General
