DP-01FX Appendix
TASCAM DP-01 Owner’s Manual 59
Balanced XLR inputs
… The line of symbols on either side of the square gets shorter as the
played note approaches the “target” and the center square fills when
the string is in tune:
Changing the tuning Most instruments are tuned with A=440 Hz. If
you are playing with another instrument that cannot be tuned, you
may want to change this value, but typically there is no need.
… Use the wheel to change the reference tuning away from 440 Hz if you
need to do this.
Noise reduction
When you are recording, the background noise of microphones, or the noise
from guitar amplifiers, etc. may cause problems. The DP-01FX allows you to
“gate” this noise, and only open the gate when the input signal goes over a
certain level. This only takes effect when the
MULTI effect is enabled.
1 Press MENU, and then select the PREFERENCE menu.
2 Use the arrow keys to scroll to NSP:
Using a noise gate
like this sometimes
requires a little work to make
sure that you don’t accidentally
cut off quiet parts of a song.
Before you make a recording
using the noise gate, it’s a good
idea to rehearse the whole part
to make sure you’ve got the right
gate level.
3 Set the level at which the gate opens to a value from OFF (the gate is
always open) through
1 (the gate will open easily, with very quiet
sounds) to
60 (a lot of force—quite loud sounds—is needed to open
the gate).
----- Tuner ----
Cal: 440Hz
G
| K |
-- PREFERENCE --
Post : 1.5Sec
EQ FRQ:
NSP . 10 l
To Next Page
Loading...
