Circuit Diagram Description
Load Handling System
CN1P-4
CN1P-5
CN1P-28
BL 8
MODE SEL 2
MODE SEL 1
7 Truck model selection terminals
The relevant truck model is selected by turning
on or off each model selection switch.
MODE SEL 1 MODE SEL 2
1 to 1.8 ton
trucks
OFF OFF
2 to 2.5 ton
trucks
ON OFF
3 to 3.5 ton
trucks
ON ON
Note: The load handling unit differs depending
on the truck model. Therefore the load
handling unit is not interchangeable,
regardless of the truck model switch
selection.
Note: Although the circuit diagram on the
left shows some switch symbols, those
switches are not installed on the truck.
To Next Page
