- 15 -
2. ELECTRICAL PARTS AND PROCEDURES FOR CHECKING
■Removing the inverter unit (1-, 2- and 3-ton class trucks with an Orbitrol steering system)
Pass screws (M4 x 20 mm or longer) through
tapped through-holes in the aluminum inverter
base and remove the inverter unit from its
aluminum n.
Top view
Thru holes
Do not hold the inverter unit
by the cover’s grooves.
Do not hold the connectors.
Thru holes
■ CAUTION
Do not hold the inverter unit by the cover’s grooves to detaching the inverter unit. Do not hold
the controller assembly by the connectors to lift it; otherwise there is a risk of damaging the cover or
boards or loosening the inverter seal.
To Next Page
