1
POWER
- 012345678 9 10
2
TRAVEL SPEED LIMIT
km/h 345678910 12 14 16
3
LIFT SPEED
% 50 55 60 65 70 75 80 85 90 95 100
4
LIFT INCING LEV.
% 0 5 10 15 20 25 30 35 40 45 50
5
TILT SPEED
% 0 10 20 30 40 50 60 70 80 90
6
ATT1 SPEED
% 0 10 20 30 40 50 60 70 80 90
7
ATT2 SPEED
% 0 10 20 30 40 50 60 70 80 90
8
SWITCH BACK REG.
% 0 10 20 30 40 50 60 70 80 90
9
ACCELERATOR OFF REG
% 0 10 20 30 40 50 60 70 80 90
10
BRAKE REG.
% 0 10 20 30 40 50 60 70 80 90
11
ANTI ROLL BACK
% 0 10 20 30 40 50 60 70 80 90
12
ACCELERATOR STAGE
- 012345678 9 10
13
SPEED ALARM OUTPUT SPEED
km/h 345678910 12 14 16
14 STEERING SSC LEVEL km/h 345678910 12 14 16
15
16
SPEED LIMIT LEVEL
km/h 345678910 12 14 16
1
SEAT SW
2
SPEED㩷㪣㪠㪤㪠㪫䇭㪪㪠
3
S MODE LIMIT
4
NEUTRAL SAFTY LOCK ACCEL.
-
5
NEUTRAL SAFTY LOCK PUMP LEV.
-
6
SPEED LIMIT
-
7
LIFT DOWN SWITCH
8
PUMP ACCELERATION MODE
-
9
SEAT SW DETECTION TIME
sec 0112233444.5 5
10
SEAT SW OFF DELAY TIME
sec 0246810 15 20 30 60 㺙
11
SPEED LIMIT RATE BATT
% 0 10 20 30 40 50 60 70 80 90
12
PUMP UNIT LIMIT RATE
% 0 10 20 30 40 50 60 70 80 90
1 OVER DISCHARGE LEVEL - 12345678910
2 AUTO POWER OFF TIME 0 15
3 AH䇭METER DISPLAY
ATE
4 HEATER
5 SPEED MODE LIMIT
6 PASS WORD SET
7 BATTERY CAPACITY 935
8 CONTRAST 45
9 CYLINDER 012345678 9 10
11 INT BUZZER TIME 12345678910
PARAMETER 3
1-44 46-90
OFF ON
OFF ON
1-14 16-90
TOTAL DRIVE PUMP WORK TRAVEL
OFF ON
No. 0 1
OFF
7 8 109562
OFF ON
OFF ON
OFF ON
HNLowSL
ON
ON
OFF ON
OFF
ON
OFF
34
PARAMETER 1PARAMETER 2
FB-8 Parameter Setting Table
Factory settings
Screen display Item Description
Unit
Remarks
Travel speed acceleration mode numbers
Max. speed in the “turtle” mode
Lift conduction ratio limit
Lift inching conduction ratio limit
Tilt conduction ratio limit
ATT1 conduction ratio limit
ATT2 conduction ratio limit
Switchback regeneration intensity
Accelerator-off regeneration intensity
Brake OFF regeneration intensity
Anti-rollback regeneration intensity
Accelerator stage mode numbers
Speed at which alarm output is started with speed alarm output mode enabled
Lower speed limit when steering SSC is activated
The speed obtained when the max. speed limit flag is enabled.
Seat switch enabled
15 km/h or less
S mode disabled
Accelerator pedal neutral safety enabled
Load-handling neutral safety enabled
Max. speed limit enabled
Lift-down switch ON
Lift acceleration mode: High/N/Low/Super Low
The time required for seat switch OFF to be enabled.
The reset delay time after seat switch OFF is detected.
Truck speed limit rate that becomes effective when the overdischarge alarm
signal is present.
Lift duty factor that is used when the overdischarge alarm signal is present.
Battery discharge indicator level at which overdischarge signal is issued.
The time required for auto power-off function to be enabled.
Items to be displayed on hour meter when key switch is turned on.
Not settable
Locked with the turtle switch pressed
Password mode ON/OFF
Battery capacity selection
Specify if an optional load meter is installed.
Number of beeps by buzzer
Travel speed acceleration level
Truck speed limit level
Lift speed level
Lift inching level
Tilt speed level
ATT1 speed level
ATT2 speed level
Switchback regeneration level
Accelerator-off regeneration level
Brake OFF regeneration level
Anti-rollback regeneration level
Accelerator stage level
Speed alarm output level
Steering SSC level
Max. speed limit level
Flag setting (1)
Speed limit, vehicle inspection specifications
Flag setting (3)-1
Flag setting (3)-2
Flag setting (3)-3
Max. speed limit enabled
Flag setting (2)-1
Flag setting (2)-2
Seat switch detection time
Seat switch OFF delay time
Truck speed limit rate that becomes effective
when the overdischarge alarm signal is present.
Load-handling operation limit rate during overdischarge
Overdischarge output level
Auto power-off time
Hour meter display switching over
Heater ON/OFF control
Fixed in the “turtle” mode
Password setting
Battery capacity
Contrast adjustment
Load meter constants
Number of beeps made by interlock buzzer
10: unlimited
0, 9, 10: OFF, 1: VM 1t, 2: VM 2t,
3: VM 3t, 4: VM 3.5t, 5: VFHM 1t,
6: VFHM 2t, 7: VFHM 3t, 8: VFHM 3.5 t
Factory setting
Fixed to OFF
Settable in minutes. 0: OFF
The numbers correspond to
the battery meter level.
Note displayed. Always OFF.
100
100
100
100
100
100
100
100
330
400
450 485 545
565
600
700
865
100
To Next Page
Loading...
