TDK-Lambda G10-500 - Page 136

128
SYSTem:REMote[:STATe] <DSC>
Function Sets the Power Supply control source (front panel or communication) to
local, remote, or LLO mode.
Local – Enables the front panel control.
Remote – Disables the front panel settings change.
LLO – same as remote + disable front panel unlock by the front panel.
Deactivates LLO only by communication or AC recycle.
Parameters
0|1|2 or LOC|REM|LLO
Query
SYSTem:REMote[:STATe]?
Return
<DSC> LOC|REM|LLO
NOTE:
System state changes from LOC to REM if any communication command is received.
System state changing from LLO to REM after AC power recycle.
SYSTem:SENSe[:STATe] <DSC>
Function
Selects the output sensing point - local or remote
Parameters
0|1, LOC|REM, OFF|ON
Query
SYSTem:SENSe[:STATe]?
Return
<DSC> LOC|REM
SYSTem:SLEW[:STATe] <DSC>
Function Sets OFF / Voltage / Current reference slew control.
OFF – Slew control is disabled.
VOLT – Voltage reference slew control enabled.
CURR – Current reference slew control enabled.
Parameters
0|1|2 or OFF|VOLT|CURR
Query
SYSTem:SLEW[:STATe]?
Return
<DSC> OFF|VOLT|CURR
SYSTem:TEMPerature[:AMBient]?
Query
Returns ambient temperature
Unit
ºC
Return
<NR1>
Example
25
SYSTem:VERSion?
Function
Returns SCPI language version
Return
<SRD> 1999.0