TDK-Lambda G30-170 - Output Commands

90
RST
Function
Reset setting. Refer to Table 3-5.
Returns
<DSC> OK
\
Function Repeat last command. If \<CR> is received, the Power Supply will repeat the last
command
Returns
<DSC> OK
FRST
Function
Restore factory reset parameters. Refer to Table 3-5 & Table 3-6
Returns
None
NOTE:
Factory Reset does not affect advanced parallel configuration acknowledgment (does not affect
power supply configuration (Single, Master or Slave roles does not change).
5.10.6 Output Commands
PV <NR2>
Function
Set digital programming output voltage value in Volts
Parameters Range is limited by the Power Supply model, OVP and UVP settings. Refer to
Table 5-4
Query
PV?
Returns
<NR2> 5-digits format
MV?
Query
Returns a measured output voltage
Returns
<NR2> 5 digits format
PC <NR2>
Function
Set digital programming output current value in Amperes
Parameters
Range is limited by the Power Supply model. Refer to Table 5-5.
Query
PC?
Returns
<NR2> 5-digits format
MC?
Query
Returns a measured output current
Returns
<NR2> 5 digits format