TDK-Lambda G30-170 - System Subsystem

124
5.14.10 SYSTem Subsystem
SYSTem[:COMMunicate]:ADDRess <NR1>
Function
Sets the Power Supply communication address.
Parameters
0…31
Query
SYSTem[:COMMunicate]:ADDRess?
Return
<NR1> 0…31
NOTE:
Power Supply addressing is lost after an address change.
SYSTem[:COMMunicate]:BAUDrate <DSC>
Function
Sets a serial communication Baud Rate (including multi-drop).
Parameters
9600|19200|38400|57600|115200 or 0|1|2|3|4
Query
SYSTem[:COMMunicate]: BAUDrate?
Return
<NR1> 9600, 19200, 38400, 57600, 115200
SYSTem[:COMMunicate]:INTerface <DSC>
Function Sets a communication interface.
The Power Supply addressing is lost after the communication interface
change.
Parameters
0|1|2|3|4, RS232|RS485|LAN|USB|OPTion
Query
SYSTem[:COMMunicate]:INTerface?
Return
<DSC> RS232, RS485, LAN, USB, OPT
SYSTem[:COMMunicate]:LAN:HOST?
Function
Reads hostname. LAN specific command.
Return
<SRD> up to 15 characters long
Example
G10-500-<X>
NOTES:
<X> represents a running number (1, 2, 3, etc…) according to the number of Power Supplies from
the same type.
A number is added only if at least 2 Power Supplies of the same type are connected to the same
network.