tecan ls series - Page 83

6. LSServer, Scanner Shell and Download
2004-11 Operating Manual for the LS Series Scanner No. 30001798 Rev. No. 1.5 6-53
Save…
In the Measurement Control dialog box, click Save… to save the current
measurement parameters under the selected filename. The standard Windows
file
Save As dialog box appears. Click OK to save the new parameters as a
Measurement Parameter (.lsp) file and close the dialog box.
When a Measurement Parameter file is saved the currently defined measurement
parameters will be saved, which include all of the settings in the Measurement
Parameter dialog box on the General, Geometry Parameter, and Scan Settings
tabs.
Note
The selection of the slides to be processed will not be saved.
If a measurement parameter file with the same name already exists it will be
overwritten.
The
Save As dialog box:
The
Save As dialog box is the standard Windows file Save As dialog box. It
contains the following elements:
Save in
combo box
In the
Save in combo box, select the drive and the folder in
which the measurement parameter file should be saved.
Workspace
list box
The
Workspace list box shows the files and folders selected in
the Save in combo box.
File Name edit
box
Enter the File Name for your measurement parameter file or
select one from the list.
Save as type
combo box
All Tecan measurement parameter files are saved with the file
extension
*.lsp.
Save button Click the Save button to save the current measurement
parameters in a file with the extension *.lsp.
Cancel button Click the Cancel button to close the dialog box without saving.