Technics EAH-AZ100 - Pair the Earphones with a Subsequent

Important:
R Depending on the connected Bluetooth
®
device, a loud sound may be output during playback.
Check the volume setting of the Bluetooth
®
device before starting playback.
1 Install and launch the [Technics Audio Connect] app on the subsequent Bluetooth
®
device.
2 Follow the on-screen instructions.
Note:
R If you pair a device when the maximum number of paired Bluetooth
®
devices is exceeded,
previously paired devices will be overwritten. To use overwritten devices again, pair them
again.
R Pairing a subsequent device is easier if you turn off Bluetooth
®
in the first device.
R When pairing a subsequent device, the earphones will cancel pairing mode and go into
connection standby mode if the device is not connected within 5 minutes. Pair again.
R The unit remembers the last connected device. The unit may connect automatically after it is
turned on.
R The unit can connect to up to 3 Bluetooth
®
devices at the same time.
“Establish multi-point connections”, Page 40
Pair the earphones with a subsequent Bluetooth
®
device
without the app
You can pair up to 10 Bluetooth
®
devices with the earphones.
R When pairing with LE Audio compatible Bluetooth
®
devices
“Number of LE Audio connections”, Page 55
You can pair by using the touch sensors on the earphones.
(Example)
R Using the earphones with a smartphone as the first device and a computer as the second
device
Important:
R When pairing, keep the Bluetooth
®
device and earphones close together. (Within about 1 m)
R Depending on the connected Bluetooth
®
device, a loud sound may be output during playback.
Check the volume setting of the Bluetooth
®
device before starting playback.
1 Put both earphones (L and R) into the charging cradle and charge.
2 Take out both earphones (L and R) from the charging cradle and wear them.
3 Touch and hold both touch sensors (L and R) at the same time until you hear the pairing
sound.
R A message about starting to pair plays, and a melody repeats.
To listen to the melody of the EAH-AZ100, click {{"Here"|tolink("https://
eww.pavc.panasonic.co.jp/avcacc/technics/sound-data/Pair_const_az100.wav")}}.
To listen to the melody of the EAH-AZ80/EAH-AZ60M2/EAH-AZ40M2, click {{"Here"|
tolink("https://eww.pavc.panasonic.co.jp/avcacc/technics/sound-data/Pair_const.wav")}}.
4 Turn on Bluetooth
®
in the subsequent Bluetooth
®
device.
5 From the Bluetooth
®
menu in the subsequent Bluetooth
®
device, select the earphones.
R If you are asked to input a passkey, input the earphone passkey “0000” (four zeros).
36
Let’s Get Started