8.1.2.1 Manual programming of timer
> Use the Menu key to call up the Main menu.
> Use the arrow keys up/down to mark the line
Manage timer.
> Confirm by pressing OK.
The sub-menu Manage timer will be displayed.
(Fig. 8-4)
> Use the arrow keys up/down to select the type of
timer you wish to programme.
> Press the OK key to go to the entry window used for
programming a new timer event. (Fig. 8-5)
To programme a timer, proceed as follows:
> Use the arrow keys to mark the upper line of the
menu.
> Press the OK key.
> In the selection window that is now displayed, use the
arrow keys up/down to select the desired source
(TV or Radio).
> Confirm by pressing OK.
Now, depending on the previous setting, the TV resp.
the radio programme list will be displayed.
> Now use the arrow keys to mark the desired pro-
gramme.
> Use the arrow keys up/down to move around the
list one line at a time.
> Use the arrow keys left/right to move backward
or forward in the list one page at a time.
> Press the OK key to accept this into the timer.
Date
> Use the arrow keys to mark the column Date.
> Use the numeric keys to enter the date (4-digit for-
mat) of the timer event.
Start
> Use the arrow keys to mark the column Start.
> In this line, use the numeric keys to enter the star-
ting time for the timer.
Stop
> Repeat the steps as described under „Start” to enter
the stopping time (except for channel-switching timer).
48
(Fig. 8-4)
(Fig. 8-5)
To Next Page
Loading...
Need help?
General
