> Now use the arrow keys up/down to select the
type of scan you wish to perform, and confirm by pres-
sing OK.
9.4.1 Automatic scan
If this scan is selected, all the satellites listed in the menu
Antenna settings (Point 6.4 and 10.4) will be scanned auto-
matically for programmes. You can decide whether you wish
to scan for all programmes (free-to-air and encrypted) or only
for free-to-air programmes. (Fig. 9-16)
> Press the OK key to decide whether you wish to scan
only for free-to-air programmes (Free Channels) or
whether you wish to include encrypted programmes
(All channels).
> Confirm by pressing the green function key Start
scan.
Depending on the configuration of your antenna instal-
lation, a scan can take 15 minutes or more. Please
note any messages displayed on screen.
9.4.2 Satellite scan
To scan a single satellite for programmes, select the
Satellite scan option (Fig. 9-17). Here you can decide whet-
her you wish to scan for all (free-to-air and encrypted) pro-
grammes or only for free-to-air programmes.
> Press the OK key again to open the selection table for
the active satellites selected in accordance with Points
6.4 and 10.4..
> Use the arrow keys up/down to mark the menu
item All satellites, to scan all active satellites for
programmes, or mark the desired satellite to scan only
this satellite for programmes.
> Confirm by pressing OK.
> Use the arrow keys up/down to mark the field
Search mode.
> Decide by pressing the OK key whether you wish to
search only for free-to-air programmes (Free
Programmes) or whether you want to include
encrypted programmes in the search (All
Programmes).
> Now use the arrow keys up/down to mark the field
Start search and press OK to confirm. The scan
will be started. Please note any additional messages
displayed on screen.
> You can abort the search by pressing the red function
key.
82
(Fig. 9-16)
(Fig. 9-17)
To Next Page
Loading...
Need help?
General
