TechniSat DIGITRADIO 10 IR

105
DE
EN
NL
FR
6.4 General device functions
6.4.1 Switching on the device
> First prepare the DIGITRADIO 10 IR for operation as described in Sections6.3.1
and 6.3.4.
> Press the On/Standby buon (18) on the remote control to turn on the
DIGITRADIO 10 IR.
Aer switching on the device for the first time, you must first configure the
first installation wizard. There are details of this in Section 8.
6.4.2 Switching o the device
> By briefly pressing the On / Standby buon you can switch the device to
standby mode. [Standby] appears briefly on the display. The date and time
are shown on the display. The display brightness in standby mode can be
adjusted by following the instructions in Section 16.3.