RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 7.31
7.23. DISASSEMBLING THE UP-DOWN MOTOR BRUSHES
Figure 7.23-1
This operation cannot be carried out on
all the motor models.
Carry out the procedures described in paragraphs
7.8. “Disassembling the motor guard” and 7.10.
“Disassembling the front plate”.
1. Manually, or using a small flat blade
screwdriver, unscrew the motor brush cap a.
2. Pull out the BRUSHES b.
To reassemble the BRUSHES, carry out the
above steps in reverse order.
To Next Page
Loading...
