Technogym Spazio Forma - Modifying the Working Parameters; Hours of Machine Operation; Distance Covered

SPAZIO FORMA: Service & Maintenance manual - rev. 1.0
Page 9.3
9.3. MODIFYING THE WORKING PARAMETERS
The procedure for setting the values of the machine’s working parameters (for example, after having
replaced the CPU board) is called up by simultaneously pressing the “1”, “3” and “4” keys with the
machine in standby mode. The machine display shows:
PA SSWORD
0
To access the procedure, type in the password which protects against unauthorized use. After typing
in the password “2709” and pressing “Enter” to proceed, the machine display will show:
9.3.1. HOURS OF MACHINE OPERATION
The total hour count of machine on-time.
O N H O U R S =
XX
Use the number keys to change the displayed value or press “Enter” to proceed.
9.3.2. HOURS OF TREAD-BELT MOTOR OPERATION
The number of hours for which the tread-belt motor has been running.
M O T O R H O U R S =
XX
Use the number keys to change the displayed value, or press “Enter” to proceed.
9.3.3. MINUTES OF UP-DOWN MOTOR OPERATION
The number of minutes for which the up-down motor has been running.
U P - D O W N M I N =
XX
Use the number keys to change the displayed value, or press “Enter” to proceed.
9.3.4. DISTANCE COVERED
The number of Km covered by the machine.
K M C O V E R E D =
XX
Use the number keys to change the displayed value, or press “Enter” to proceed.