SPAZIO FORMA: Service & Maintenance manual - rev. 1.0
Page 7.19
7.15. DISASSEMBLING THE ELECTRONIC CIRCUIT BOARDS
Figure 7.15-1
Carry out the procedures described in paragraph
7.8. “Disassembling the motor guard”.
1. Back off the 2 screws a using a 5-mm hex T
wrench.
2. Cut the cable locking strips.
3. Unplug connectors b, the cables connected to
the filter and the ones from the inverter.
Figure 7.15-2
4. Remove the 4 fasteners c.
5. Remove the electrical box.
Place the box on a work bench.
Continued on the following page →
To Next Page
Loading...
