SPAZIO FORMA: Service & Maintenance manual - rev. 1.0
Page 10.3
10.3. BIMONTHLY MAINTENANCE OPERATIONS
These operations can be performed by the machine owner and do not require any
special skills.
The bimonthly maintenance operations involve simple cleaning and lubrication actions and checks
on the state of wear, in order to ensure correct and safe operation of the machine.
For the bimonthly maintenance of the machine, proceed as follows:
10.3.1. INTERNAL CLEANING OPERATIONS
1. Turn off the machine, by placing the switch in the 0 (OFF) position.
2. Unplug the mains lead from the wall outlet.
3. Open the motor guard.
4. Clean the interior using a vacuum cleaner, taking particular care with the tread-belt motor, the
inverter and the electronic circuit boards.
WARNING: when carrying out these operations, be careful not to damage the cables.
5. Move the machine and clean the floor under the machine using a vacuum cleaner.
10.3.2. CHECKING THE STATE OF WEAR
1. With the machine stopped, check the state of wear of the entire surface of the tread-belt, turning
it by hand. If it shows signs of damage or wear, replace it or call in the authorized Technogym
Technical Service.
10.3.3. CHECKING THE TENSION AND CENTERING OF THE TREAD-BELT
1. With the machine running at minimum speed, attempt to stop the tread belt by stepping on it. If
the tread belt slips, replace it or call in an authorized Technogym service technician.
2. With the machine running at approximately 10 Km/h, check the centering of the tread-belt. If
any problems are observed, call in the authorized Technogym Technical Service or adjust the
centering.
10.3.4. CHECKING THE DISPLAY
1. Check the operation of all the keys on the keyboard.
2. Check the operation of all the LEDs and the buzzer.
10.3.5. CHECKING THE WEAR OF THE RUBBER HANDLEBAR COVER
1. Check the state of wear of the rubber covers on the 2 side handlebars and on the center
handlebar. Replace if there are evident signs of wear.
To Next Page
Loading...
